Roberts Radio Clock Radio CR9923 User Guide

CR9923  
2 Band Single Alarm  
Clock Radio  
PM  
FM  
MW  
540  
TUNING  
CR 9923  
2 Band Clock Radio  
Please read this manual before use  
 
Controls (front)  
6
7
8
6. Alarm indicator.  
7. PM indicator.  
8. Tuning control.  
PM  
FM  
MW  
540  
TUNING  
CR 9923  
2 Band Clock Radio  
If you need any further advice, please call our Technical Helpline on :-  
020 8758 0338 (Mon-Fri)  
2
 
Controls (left and right side)  
On  
Off  
Radio  
Buzz  
9. Function switch.  
10. Dimmer switch.  
11. Waveband switch.  
12. Volume control.  
13. Battery compartment  
9
MW  
FM  
11  
12  
DIMMER  
High  
10  
Low  
VOLUME  
13  
3
 
Switching on  
1. Place your clock radio on a flat surface. Plug the power cord into the  
wall socket and switch on. The clock display will flash 12.00.  
ON  
PM  
FM  
MW  
540  
TUNING  
CR 9923  
2
Band Clock Radio  
TIME  
Setting the time  
1. Press and hold down the TIME button.  
Minute  
Hour  
2. Whilst holding down the TIME button press the Hour or Minute  
buttons to set the time. Release the buttons when the correct time is  
reached. The clock uses a 12 hour display with an PM indicator.  
Ensure that the correct 12 hour cycle is selected.  
PM  
If you need any further advice, please call our Technical Helpline on :-  
020 8758 0338 (Mon-Fri)  
4
 
Listening to the Radio  
On  
Off  
Radio  
Buzz  
1. Switch on the radio by sliding the Function switch to the 'On'  
position.  
2. Select the required waveband using the Waveband selector  
switch.  
MW  
FM  
3. Tune in to the desired station by rotating the Tuning control.  
The Wire aerial located on the rear of your clock radio is for FM  
reception. The wire should be fully extended and positioned for  
optimum reception.  
VOLUME  
On  
Off  
FM  
MW  
Radio  
Buzz  
For MW reception there is a built in ferrite aerial. Rotate the your  
clock radio to the position giving best reception.  
540  
4. Adjust the volume by rotating the Volume control.  
TUNING  
5. The radio can be switched off by sliding the Function switch to the  
'Off' position.  
5
 
Setting alarm time  
ALARM/OFF  
Minute  
Hour  
1. Press and hold down the ALARM/OFF button.  
2. Whilst holding down the ALARM/OFF button press the Hour or  
Minute buttons to set the time. Release the buttons when the  
correct alarm time is reached. The clock uses a 12 hour display  
with a PM indicator. Ensure that the correct 12 hour cycle is  
selected.  
PM  
Checking the alarm time  
1. To check alarm time, press and hold down the ALARM/OFF button  
the display will show the alarm time.  
ALARM/OFF  
PM  
If you need any further advice, please call our Technical Helpline on :-  
020 8758 0338 (Mon-Fri)  
6
 
Setting the alarm to wake to buzzer  
1. Set the alarm time as previously described. Set the Function switch  
to the 'Buzz' position. The Alarm indicator will light.  
On  
Off  
Radio  
Buzz  
PM  
The alarm will sound every day at the preset time for 1 hour 59  
minutes. To switch off the alarm until the next day press the ALARM/  
OFF button. To turn off the alarm permanently set the Function  
switch to the 'Off' position.  
Setting the alarm to wake to radio  
1. Set the alarm time as previously described. Set the Function switch  
to the 'Auto' position. The Alarm indicator will light.  
On  
Off  
Radio  
Buzz  
Ensure that the volume is set to the correct level and the desired  
station is tuned in.  
PM  
The alarm will sound every day at the preset time for 1 hour 59  
minutes. To turn off the alarm until the next day press the ALARM/  
OFF button. To turn off the alarm permanently set the Function  
switch to the 'Off' position.  
7
 
Snooze control  
1. The radio or buzzer alarm can be silenced for 9 minutes by pressing  
the SNOOZE button. This sequence can be repeated whilst the  
alarm is sounding.  
SNOOZE  
Sleep timer  
SLEEP  
The radio can be set to turn off after a preset time has elapsed.  
PM  
1. Press and hold down the SLEEP button.  
2. Whilst holding down the SLEEP button set the sleep time using  
the Hour and Minute buttons (maximum 1 hour and 59 minutes in  
1 minute steps).  
The radio will switch off after the sleep time has elapsed.  
3. To cancel the sleep function before the preset time has expired,  
press the SNOOZE button.  
SNOOZE  
If you need any further advice, please call our Technical Helpline on :-  
020 8758 0338 (Mon-Fri)  
8
 
Dimmer Switch  
DIMMER  
High  
The DIMMER switch located on the left side of your clock radio will  
allow you to adjust the intensity of the clock display to suit room  
brightness.  
Low  
Circuit Features  
Specifications  
Loudspeaker  
8 ohms  
Power Requirements  
Mains :  
Back-up Battery  
AC 230 volts, 50Hz  
only  
Output power 250mW  
:
IEC size 6LR61 (6F22, PP3)  
Aerial System  
FM  
Wire Aerial  
Frequency Coverage  
FM  
MW  
87.5 - 108MHz  
525 - 1610kHz  
MW  
Built-in Ferrite aerial  
ROBERTS RADIO LIMITED  
PO BOX 130  
MEXBOROUGH  
SOUTH YORKSHIRE  
S64 8YT  
The Company reserves the right to amend the specification without notice.  
9
 
General  
E(Earth)  
The wire coloured BLUE must be  
connected to the terminal marked  
N or coloured BLACK.  
The wire coloured BROWN must  
be connected to the terminal  
marked L or coloured RED.  
Do not allow this unit to be exposed to water or steam. It is recommended  
that the FM band be used wherever possible as better results in terms  
of quality and freedom from interference will usually be obtained than on  
the MW band.  
Brown(Live)  
Blue (Neutral)  
3 amp  
L
Mains supply  
The CR9923 will operate from a supply of AC 230volts, 50Hz  
N
only.  
For your convenience this product is supplied with a plug which is fitted  
with a fuse of the appropriate rating. If the plug supplied is not suitable  
for your socket outlet, it should be removed by unscrewing the plug top,  
the terminal screws and removing the cable.  
The correct style of plug to suit your household together with a correctly  
rated fuse should be fitted.  
Cord  
Fuse  
This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug  
(BS1363). If another type of plug is used a 5A fuse should be fitted in the  
plug, adaptor or distribution board.  
IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN.  
IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN  
Back-up Battery (not necessary for the unit to function)  
Slide the battery cover downwards. Remove the battery cover.  
IMPORTANT. DO NOT make any connection to the larger terminal which  
is marked with the letter E or by the safety earth symbol  
Green or Green-and-yellow.  
or coloured  
Fit a 9 volt IEC size 6LR61 (6F22, PP3) or equivalent battery into the  
compartment. Replace the battery cover.  
The wires in the mains lead are coloured in accordance with the following  
codes :-  
BLUE - NEUTRAL  
As these colours may not correspond with the coloured markings  
identifying the terminals in your plug, proceed as follows:-  
BROWN - LIVE  
The time and alarm settings will be retained during a temporary failure  
of the AC mains supply. The LED display will not be operational. The  
display will be extinguished to conserve battery life.  
If you need any further advice, please call our Technical Helpline on :-  
020 8758 0338 (Mon-Fri)  
10  
 
Guarantee  
This clock radio is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown,  
subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge.  
The guarantee does not cover:  
1. Damage resulting from incorrect use.  
2. Consequential damage.  
3. Product with removed or defaced serial numbers.  
Procedure:Any claim under this guarantee should be made through the dealer from whom the instrument was purchased. It is likely that your Roberts' dealer will be  
able to attend to any defect quickly and efficiently but should it be necessary the dealer will return the instrument to the company’s service department for attention.  
In the event that it is not possible to return the instrument to the Roberts' dealer from whom it was purchased, please contact Roberts Radio service department at  
the address shown below before taking further action.  
These statements do not affect the statutory rights of a consumer.  
ROBERTS RADIO TECHNICAL SERVICES DEPARTMENT  
97-99 Worton Road  
Isleworth Middlesex  
TW7 6EG  
Technical Helpline :- 020 8758 0338 (Mon-Fri during office hours)  
Issue 1  
 

PYLE Audio TV Mount PWLB805 User Guide
Quantum Network Card PX500 Series User Guide
Renesas Computer Hardware R8C 27 User Guide
Roland Musical Instrument Amplifier KC 110 User Guide
Rosewill Flat Panel Television R908TV User Guide
Samsung PDAs Smartphones SPH A400SS User Guide
Samsung Security Camera SPD 3300 User Guide
Sanyo Flat Panel Television DP19640 User Guide
Seagate Computer Drive STCD500100 User Guide
Sega Video Game Console 999 1108 User Guide